How to apply UltraGlozz®
Restoration of a worn surface
|
How to apply UltraGlozz® Restoration of a worn surface
|
| A. Here we will show you how to take a faded surface on boats, RVs,
cars and motorcycles and bring the luster back to life - with a lasting
shine and protective coating. Here we use a car from 1995 for
demonstration purposes. Begin with a clean and 100% dry surface.
|
| B, We recommend using a strong polishing machine like
an orbital sander onto which you apply a sponge. You can also do this by
hand but regardless of which product you use you will never be able to
apply using an even pressure as you can with a machine. Here we use a
Ridgid polisher with a 6" sponge. There are cheaper and OK alternatives - e.g. a Bosch PEX 400 AE orbital sander. |
 |
| C. Apply UltraGlozz® Superpolish to the
sponge and begin to buff /polish the worn surface. Keep polishing until
the liquid has dissapeared into the surface and a nice bright finish appears
|
|
|
 |
| D. Remember to protect your
rubber trim. You can use UltraGlozz® Superpolish on any surface for a superior shine and a longer laster protection, but NOT on the rubber
trim. Here we recommend that you use either UltraGlozz® Vinyl or UltraGlozz® SuperVinyl. Simply shake the bottle of UltraGlozz® SuperVinyl and apply with a sponge manually to all rubber trim areas
before applying UltraGlozz® Superpolish
|
 |
 |
E. Continue with polishing the surface until the “liquid” paste has completely disappeared from the surface and a shiny luster is shown as seen in the picture on the left
|
|
F. Now make sure that the entire surface is nice and smooth and that all polish residues are removed
|
|
G. Now rip off a piece from a larger sponge and apply UltraGlozz® Superpolish to the sponge (See picture “D” as well) Here you will see how much easier UltraGlozz® Superpolish is to use !
|
|
H. Apply evenly to the ENTIRE Surface and LET DRY COMPLETELY for about 15-20 minutes (or enough time to dry)
|
 |
 |
 |
|
I. Now wipe off the dried polish with a clean, dry and soft rag or cloth. Wait 24 hours and.... Voila ! The best shine and strongest surface protection available is achieved. |
 |
 |
 |
 |
| Rear Panel BEFORE application of UltraGlozz® Superpolish | Rear panel after application with UltraGlozz® Superpolish |
Maintenance of a good surface
|
| Simply begin with step G, H and I |
 |
 |
|
Back before Application |
Back side after the application following the steps as listed above |
 ......and then the final result
|
